S9/N9 Unlock
NOTE 9 - N960U / N960U1  (SPRINT - VERIZON - TMOBILE LOCKED) 
*** FOR AT&T OR XFINITY OR ANY VARIANT NOTE 9 (N960U / N960U1) ASKING FOR UNLOCK CODE READ ALTERNATIVE STEPS BELOW.

1. MUST CHECK ORIGINAL IMEI IS NOT WIPED. NOT RESPONSIBLE IF DONT CHECK. BEST WAY *#0011# AND GET A PICTURE FROM THE CLIENTS. ALSO MAKE SURE MIPI TEST IS PASS.

2  CLICK TM/SPR UNLOCK TAB. 
   CLICK PORT DROP DOWN BOX AND SELECT CORRECT MODEM PORT
   CLICK ADB DEVICE DROP DOWN BOX AND SELECT CORRECT DEVICE. (IF DOESNT SHOW OR ANY ERROR CLICK RESTART ADB SERVER, WAIT 10 SECONDS AND THEN RETRY)

3.  SELECT CORRECT MODEL AND PRESS READ SEC BOX.
   ** IF DOING DIRECT ON CLIENT PC UNCHECK THE REMOTE BOX FOR FASTER READ
   THE PHONE WILL REBOOT 3 TIMES AND THEN EXE WILL GIVE YOU A POP-UP BOX.
   DO-NOT CLICK OK, WAIT UNTIL THE PHONE IS IN UPLOAD MODE AND CONNECTED TO YOUR PC AND DRIVERS INSTALLED. CHECK DEVICE MANAGER AND MODEM PORT WILL SHOW UP.
   

4. CLICK OK AND EXE WILL START READ THE SECURITY. THIS CAN TAKE 4-6 MIN SO BE PATIENT. DO NOT CONNECT ANY OTHER PHONE DURING THIS DURATION.
   ** IF READ SECURITY FAILS. RESTART AND RETRY BUT CHOOSE N960U1 AS MODEL.
   ** IF STILL FAILS THEN FLASH MODEM FROM LINK BELOW AND RETRY. AFTER MODEM FLASH TRY FIRST WITH N960U AS MODEL AND IF FAILS RETRY WITH N960U1 AS MODEL.
      (N960USQU1ARG4_FACTORY_MODEM. CAN DOWNLOAD FROM THIS LINK: https://www.amazon.com/clouddrive/share/4sUl43p22Q4mr1eze8P8jihoPXq6Dwvtuwr00bl1h9V )


5. ONCE SECURITY DATA IS READ, PHONE WILL REBOOT FROM UPLOAD MODE AND THEN REBOOT ONCE MORE. JOB # WILL BE DISPLAYED IN LOG.
   CHECK MSLCERT JOBS TAB AND YOU CAN TRACK THE UNLOCK. WAIT TILL SAYS ACCEPTED.
   ALL NOTE 9 WILL COST 10 CREDITS. IF WILL APPEAR AS 9-CREDITS FOR MSLCERT TAB AND 1-CREDIT IN REPAIR TAB AS "SECUNLOCK"

6. ONCE MSLCERT JOB SAYS ACCEPTED, MAKE SURE THE RESET MSL(WRITE SECURITY) BOX IS CLICKED AND THEN CLICK WRITE SEC AND WAIT TILL FINISH.
   CLICK WRITE SEC ONLY AND ONLY IF MSLCERT JOB SAYS ACCEPTED.


7. WRITE STOCK MODEM TO PHONE, IF FACTORY MODEM WAS FLASHED FOR UNLOCK.

** ALL JOBS FOLLOW SAME TIME FRAME AS IMEI REPAIR  15 MIN - 96 HOURS MAX 



---------------------------------------------------------------------------------------------------------------------------------------------------------------

NOTE 9 - N960U / N960U1  (AT&T OR XFINITY OR ANY VARIANT ASKING FOR UNLOCK CODE)

1. MUST CHECK ORIGINAL IMEI IS NOT WIPED. NOT RESPONSIBLE IF DONT CHECK. BEST WAY *#0011# AND GET A PICTURE FROM THE CLIENTS. ALSO MAKE SURE MIPI TEST IS PASS.
   INSERT DIFFERENT CARRIER SIMCARD AND MAKE SURE PHONE IS ASKING FOR UNLOCK CODE. (IF SAYING INVALID SIM MSG OR HAS UNLOCK APP REFER TO THE STEPS ABOVE)

2. CLICK MSL UNLOCK TAB
   CLICK MSLCERT UNLOCK TAB
   MAKE SURE NEW AT RIL BOX AND QUALCOMM IS SELECTED
   CLICK PORT DROP DOWN BOX AND SELECT CORRECT MODEM PORT
   CLICK ADB DEVICE DROP DOWN BOX AND SELECT CORRECT DEVICE. (IF DOESNT SHOW OR ANY ERROR CLICK RESTART ADB SERVER, WAIT 10 SECONDS AND THEN RETRY)

3. CLICK UNLOCK
   READ AND ACCEPT TERMS ON POPUP BOX.

4. EXE WILL READ DATA AND SUBMIT FOR MSLCERT CALCULATION.

5. LOG ONTO ANYDIRECTUNLOCK.COM
    CHECK MSLCERT JOBS TAB AND YOU CAN TRACK THE JOB STATUS. WAIT TILL SAYS ACCEPTED.

6. ONCE MSLCERT JOB IS ACCEPTED, RECONNECT THE PHONE.
   REPEAT STEP 2 AND PRESS UNLOCK AGAIN AND IT WILL COMPLETE THE UNLOCK
   ONCE COMPLETED THE UNLOCK CODE WILL BE SET TO 00000000. 
   INSERT DIFFERENT CARRIER SIM AND ENTER THE UNLOCK CODE TO COMPLETE.
   THIS OPERATION CONSUMES 10 CREDITS.

 

---------------------------------------------------------------------------------------------------------------------------------------------------------------

SPRINT / VERIZON S9/S9+ (G960U / G960U1 / G965U / G965U1)


1. MUST CHECK ORIGINAL IMEI IS NOT WIPED. NOT RESPONSIBLE IF DONT CHECK. BEST WAY *#0011# AND GET A PICTURE FROM THE CLIENTS. ALSO MAKE SURE MIPI TEST IS PASS.

2. FLASH MODEM. 
   G960U / G960U1:
   FOR REV2 RF9 OR HIGHER FLASH THIS MODEM: https://www.amazon.com/clouddrive/share/a0N90zSwuCrrtJQsEGQuABFj5Cvie6qJCfFaz0Z9jWz
   FOR REV3 FLASH THIS MODEM: https://www.amazon.com/clouddrive/share/FpmJfHAsMOzyW0wkTFz7y67xJ8g6ibgH2xu1J1UmUPM

   G965U / G965U1:
   FOR REV2 RF9 OR HIGHER FLASH THIS MODEM: https://www.amazon.com/clouddrive/share/b4KSx4NW0u6kknZiOdn9VIPQGTBzUnsLUmEVdYGGlsG
   FOR REV3 FLASH THIS MODEM: https://www.amazon.com/clouddrive/share/jWfUjHJzjGKxPuvJHuBmWib1vdtVQWt53rdieSxYlXq


3. CLICK TM/SPR UNLOCK TAB. 
   CLICK PORT DROP DOWN BOX AND SELECT CORRECT MODEM PORT
   CLICK ADB DEVICE DROP DOWN BOX AND SELECT CORRECT DEVICE. (IF DOESNT SHOW OR ANY ERROR CLICK RESTART ADB SERVER, WAIT 10 SECONDS AND THEN RETRY)

4  SELECT CORRECT MODEL AND PRESS READ SEC BOX.
   ** IF DOING DIRECT ON CLIENT PC UNCHECK THE REMOTE BOX FOR FASTER READ
   THE PHONE WILL REBOOT 2 TIMES AND THEN EXE WILL GIVE YOU A POP-UP BOX.
   DO-NOT CLICK OK, WAIT UNTIL THE PHONE IS IN UPLOAD MODE AND CONNECTED TO YOUR PC AND DRIVERS INSTALLED. CHECK DEVICE MANAGER AND MODEM PORT WILL SHOW UP.
   

5. CLICK OK AND EXE WILL START READ THE SECURITY. THIS CAN TAKE 1-4 MIN SO BE PATIENT. DO NOT CONNECT ANY OTHER PHONE DURING THIS DURATION.


6. ONCE SECURITY DATA IS READ, PHONE WILL REBOOT FROM UPLOAD MODE AND THEN REBOOT ONCE MORE. JOB # WILL BE DISPLAYED IN LOG.
   CHECK MSLCERT JOBS TAB AND YOU CAN TRACK THE UNLOCK. WAIT TILL SAYS ACCEPTED.
   ALL S9/S9+ WILL COST 9 CREDITS. IF WILL APPEAR AS 8-CREDITS FOR MSLCERT TAB AND 1-CREDIT IN REPAIR TAB AS "SECUNLOCK"

7. ONCE MSLCERT JOB SAYS ACCEPTED, MAKE SURE THE RESET MSL(WRITE SECURITY) BOX IS CLICKED AND THEN CLICK WRITE SEC AND WAIT TILL FINISH.
   CLICK WRITE SEC ONLY AND ONLY IF MSLCERT JOB SAYS ACCEPTED.


8. WRITE STOCK MODEM BACK TO THE PHONE AND ENJOY!!

** ALL JOBS FOLLOW SAME TIME FRAME AS IMEI REPAIR  15 MIN - 96 HOURS MAX